Whole-House Repiping for Whitby Homes in Whitby
When a house runs on aging galvanized pipe or a problem plastic, replacing the supply lines can end a cycle of leaks and low pressure for good.
- Whole-House Repiping for Whitby Homes handled by a licensed plumber
- Cause found and shown to you before any repair
- Price explained before work starts
- Tested, cleaned up and written down when finished
- Licensed plumbing trade
- Camera before digging
- Written job notes
- Phone-only booking
Signs, filed under symptoms
- Rusty water when taps first open
- A shower that weakens the moment a sink opens
- Repeated leaks in different spots
- Polybutylene or Kitec-type pipe noted at inspection
How the job is handled
We trace the full supply layout, meter to tap, and plan a route that minimises wall openings. PEX is often used for its flexibility and fewer joints; copper is chosen where the homeowner prefers it or where it suits the layout.
Most homes can keep water service on for much of the work, with shut-offs limited to connection days. We patch access openings to a paint-ready finish or coordinate with your drywaller.
Signs you need this work
- Several pinhole leaks within a couple of years
- Galvanized steel supply lines in an older house
- Low pressure at upstairs taps
- Rusty water after the taps sit
What the plumber brings
Tools and parts that come in from the truck for this kind of call, so the fix can usually be made on the first visit:
- PEX-a tubing and manifold
- Copper for exposed and mechanical-room runs
- Drywall saw and patch kit
- Pressure test gauge
The job, step by step
- 01
We map every fixture and pipe route through the house
- 02
New lines are run through joists and walls with small access cuts
- 03
Fixtures are switched to the new lines one at a time
- 04
The new system is pressure-tested before the old lines are cut out
- 05
Access holes are closed and you get a diagram of the new runs
Symptom, cause and fix
| What you see | Usual cause | What we do |
|---|---|---|
| Low pressure, rust in water | Galvanized pipe scaled inside | Replace with PEX or copper |
| Repeated pinholes | Copper pipe wall thinning | Repipe the affected area or whole house |
| Lead service suspected | Pre-1950s supply line | Test water and plan a service replacement |
Local card: Whitby houses
Pre-1960 houses in Downtown Whitby and older parts of Oshawa may still carry galvanized lines in places. Mid-1990s to mid-2000s homes may have Kitec-type pipe that insurers and buyers often ask about.
The visit, in order
- Existing system mapped and route planned
- Permit arranged where required
- New lines run and connected fixture by fixture
- Old lines capped or removed, final pressure test
Ring us when
Plan repiping when leaks are recurring, when pressure is poor, or before a major renovation opens walls anyway.
Common questions
How many days is a repipe?
House size and access decide it. A typical detached home often takes several days.
Will my walls be damaged?
Small openings are needed. We plan routes to keep them few and patch them afterwards.